Hammer mill and Pellet Mill Replacement Parts
A Worldwide Leader in Replacement Parts for Mills Since 1934.
Upcoming Events
Our Mill Products & Services
Hammer Mills
Hammers
Rods and Spacers
Screens
Pellet Mills
Dies
Roller Shells
Die & Shell Rework
When it comes to the Jacobs screens for the Andritz hammermill and the Dupps Grindor’s, the screens from Jacob’s were always more convenient to get and lasted longer the only time we would have to change them was when stainless went through the Grindor or Hammermill. Getting screens by the pallet is far more convenient than ordering by each.
“The Jacobs Hammers are in the mill and outlasting the hammers we ran before!”
“We love your Hammers! They are more durable than the competitors, and that’s why we’re now using Jacobs Rod!”
“Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. “
“Fred wants a die like the last one. Said it is the best die he has ever run!”
“Gold star for pentagons! We are getting the best grind we have ever had and are happy about that!”
“Had Lightning Die on for 18 months on the 30 ton mill and ran 172,278 tons through it. Want one just like it for the 7932 mill. Love them!”
“Very happy with Jacobs Dies! Performing better than [Competitor]. Want another die like the last one.”
“We recently switched to Pentagon Hammers; the installer said the hammers went on so smooth, they thought something was wrong. Took 20 minutes to install 120 hammers. After a week, the hammers were inspected and there were a few sticking out. Touched them and they fell down. In the next two inspections, all hammers were down.”
“Very pleased with Bad Ax Hammers. Mill has less vibration, first corner 250 to 260 hours, 2nd corner at 180-190 and still going”