Hammer mill and Pellet Mill Replacement Parts
A Worldwide Leader in Replacement Parts for Mills Since 1934.
Upcoming Events
Our Mill Products & Services
Hammer Mills
Hammers
Rods and Spacers
Screens
Pellet Mills
Dies
Roller Shells
Die & Shell Rework
“Very pleased with Bad Ax Hammers. Mill has less vibration, first corner 250 to 260 hours, 2nd corner at 180-190 and still going”
“The Triple Threats are living up to the talk on our Bliss Mill. [Competitor] hammers are needing replaced and Jacobs’ barely looked used!”
“Jacobs rods resist grooving much better than the other brands I have used in the past.”
“Our [Competitor] die that has 500 hours on it isn’t performing as well as the Lightning Die which Currently has 6,500 hours on it. The Lightning Die is still making pellets and the [Competitor] die is struggling. Will be switching fully to Lightning Dies in the future!”
“The Jacobs Hammers are in the mill and outlasting the hammers we ran before!”
“Very happy with Jacobs Dies! Performing better than [Competitor]. Want another die like the last one.”
“We recently switched to Pentagon Hammers; the installer said the hammers went on so smooth, they thought something was wrong. Took 20 minutes to install 120 hammers. After a week, the hammers were inspected and there were a few sticking out. Touched them and they fell down. In the next two inspections, all hammers were down.”
When it comes to the Jacobs screens for the Andritz hammermill and the Dupps Grindor’s, the screens from Jacob’s were always more convenient to get and lasted longer the only time we would have to change them was when stainless went through the Grindor or Hammermill. Getting screens by the pallet is far more convenient than ordering by each.
“Jacobs rods last a full year with very little grooving, competitors rods needed changed out every 6 months due to excessive grooving.”
“Mark said been buying Jacobs Dies for 3 years with no issues for his CPM Mills.”