Hammer mill and Pellet Mill Replacement Parts
A Worldwide Leader in Replacement Parts for Mills Since 1934.
Upcoming Events
Our Mill Products & Services
Hammer Mills
Hammers
Rods and Spacers
Screens
Pellet Mills
Dies
Roller Shells
Die & Shell Rework
“The Lightning Die has increased our production 30%+. The Die has been on for 4,000+ hours and still doing great. We added storage bins, which now was a waste of money as we have increased production and use the raw materials as fast as it comes in. I can’t believe the whole industry doesn’t jump to the Lightning!”
“Both mills running Pentagons. Last sets ran for about 11 months, pushing 13,000 to 14,000 ton per week. 572,000 tons of life on hammers!”
“Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. “
“Jacobs Hammers are amazing, can hardly see any wear on them!”
“Been using Pentagon X2 Holeformance for 3 weeks in Champion Mill. 60 AMPS savings so increased Feed Rate which increased throughput 8%. The Champion capacity is 65 Million and Currently Running at 70-71 Million. Easy to install and fewer spacers! We removed [Brand X] Hammers from a 2nd Mill and replaced with Pentagon X2 Holeformance to get the same savings and increased throughput.”
“There is no comparison out there to the durability of Jacobs Hammers, they’re amazing. Hardfacing is so good, the hammers are not wearing out. Only buying Jacobs Hammers!”
“Maintenance sent the following numbers regarding 5 different feeds. Feed 1: 35% Increase in throughput Feed 2: 44% Increase in throughput Feed 3: 42% Increase in throughput Feed 4: 87% Increase in throughput Feed 5: 9% Increase in throughput.”
While running the Andritz hammer mill we were having to change the hammers every 1-2 weeks. Once we worked with Jacob’s and change the hammers along with a few other adjustments in the pattern, we were able to get 4-5 weeks of life out of the hammers.
“It will be Jacobs from here on out! The guys said Jacobs Pentagons were by far the easiest to install and they really enjoy using them versus the others.”
“The Jacobs Hammers are in the mill and outlasting the hammers we ran before!”