Hammer mill and Pellet Mill Replacement Parts
A Worldwide Leader in Replacement Parts for Mills Since 1934.
Upcoming Events
Our Mill Products & Services
Hammer Mills
Hammers
Rods and Spacers
Screens
Pellet Mills
Dies
Roller Shells
Die & Shell Rework
“The Jacobs Hammers are in the mill and outlasting the hammers we ran before!”
“1st Die ran for 18 Months on 30 TPH mill and ran 172,278 Tons. 2nd Die installed July 7th 2015 and it is over 144,000 tons now and still going!”
“Jacobs rods last a full year with very little grooving, competitors rods needed changed out every 6 months due to excessive grooving.”
“Jacobs rods resist grooving much better than the other brands I have used in the past.”
After running the Dupps Grindor’s for several months changing the Dupps hammers every 2 days, we ran a trial on the Jacob’s Hammers for the Dupps Grinder and found that we were able to get 5 days of life. We run strictly all beef and bones straight from slaughterhouses.
“Mark said been buying Jacobs Dies for 3 years with no issues for his CPM Mills.”
“There is no comparison out there to the durability of Jacobs Hammers, they’re amazing. Hardfacing is so good, the hammers are not wearing out. Only buying Jacobs Hammers!”
“Jacobs Hammers are amazing, can hardly see any wear on them!”
“Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. “
“Lightning Die has better PDI by 15%, designed right for the DDG Formulation. Very impressed with quality up and AMP draw 15% less.”