Hammer mill and Pellet Mill Replacement Parts
A Worldwide Leader in Replacement Parts for Mills Since 1934.
Upcoming Events
Our Mill Products & Services
Hammer Mills
Hammers
Rods and Spacers
Screens
Pellet Mills
Dies
Roller Shells
Die & Shell Rework
“Maintenance sent the following numbers regarding 5 different feeds. Feed 1: 35% Increase in throughput Feed 2: 44% Increase in throughput Feed 3: 42% Increase in throughput Feed 4: 87% Increase in throughput Feed 5: 9% Increase in throughput.”
“Essault Hammers lasted 11 weeks compared to regular hammers lasting 6 weeks. Ordered 2 more sets. This will be the way to go on hammers from now on!”
“Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. “
“Both mills running Pentagons. Last sets ran for about 11 months, pushing 13,000 to 14,000 ton per week. 572,000 tons of life on hammers!”
“The Lightning resulted in 48% decrease in energy with 19% increase in throughput. Savings $32K!”
When it comes to the Jacobs screens for the Andritz hammermill and the Dupps Grindor’s, the screens from Jacob’s were always more convenient to get and lasted longer the only time we would have to change them was when stainless went through the Grindor or Hammermill. Getting screens by the pallet is far more convenient than ordering by each.
“Had Lightning Die on for 18 months on the 30 ton mill and ran 172,278 tons through it. Want one just like it for the 7932 mill. Love them!”
“The Pentagon Hammer Set we have in our Roskamp meal grinder is working very well. I’ll be buying at least two more Sets of these hammers for our other machines.”
“The Triple Threat Hammers have been working exceptionally well on our Jones Mill. I have been very impressed. We weren’t getting the hours from [Competitor], and they were only lasting about 2 months. Jacobs has been running for 4 months and is still running for less money.”
“The Triple Threat Hammers are working great on my Bliss Mill! Have to order another set! Got about 5.5 months out of them; I won’t go anywhere else!”