Hammer mill and Pellet Mill Replacement Parts
A Worldwide Leader in Replacement Parts for Mills Since 1934.
Upcoming Events
Our Mill Products & Services
Hammer Mills
Hammers
Rods and Spacers
Screens
Pellet Mills
Dies
Roller Shells
Die & Shell Rework
“Very pleased with Bad Ax Hammers. Mill has less vibration, first corner 250 to 260 hours, 2nd corner at 180-190 and still going”
“Maintenance sent the following numbers regarding 5 different feeds. Feed 1: 35% Increase in throughput Feed 2: 44% Increase in throughput Feed 3: 42% Increase in throughput Feed 4: 87% Increase in throughput Feed 5: 9% Increase in throughput.”
“Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. “
“No one has better Dupps Hammers than Jacobs! We won’t be trying anyone else’s after seeing the quality!”
“Josh said the Jacobs Die has out performed anything they have used in the past. Very pleased!”
“There is no comparison out there to the durability of Jacobs Hammers, they’re amazing. Hardfacing is so good, the hammers are not wearing out. Only buying Jacobs Hammers!”
“The Jacobs Hammers are in the mill and outlasting the hammers we ran before!”
“We love your Hammers! They are more durable than the competitors, and that’s why we’re now using Jacobs Rod!”
“Been using Pentagon X2 Holeformance for 3 weeks in Champion Mill. 60 AMPS savings so increased Feed Rate which increased throughput 8%. The Champion capacity is 65 Million and Currently Running at 70-71 Million. Easy to install and fewer spacers! We removed [Brand X] Hammers from a 2nd Mill and replaced with Pentagon X2 Holeformance to get the same savings and increased throughput.”
When it comes to the Jacobs screens for the Andritz hammermill and the Dupps Grindor’s, the screens from Jacob’s were always more convenient to get and lasted longer the only time we would have to change them was when stainless went through the Grindor or Hammermill. Getting screens by the pallet is far more convenient than ordering by each.