Hammer mill and Pellet Mill Replacement Parts

"Jacobs Hammers are amazing, can hardly see any wear on them!"

"Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. "

"Essault Hammers lasted 11 weeks compared to regular hammers lasting 6 weeks. Ordered 2 more sets. This will be the way to go on hammers from now on!"

"We recently switched to Pentagon Hammers; the installer said the hammers went on so smooth, they thought something was wrong. Took 20 minutes to install 120 hammers. After a week, the hammers were inspected and there were a few sticking out. Touched them and they fell down. In the next two inspections, all hammers were down."

"Jacobs rods resist grooving much better than the other brands I have used in the past."

"Very Happy with the Lightning Die and don't want to change a thing!"

"Extremely pleased with Jacobs Dies. Currently saving 50% more tons on these dies than we were getting with a different supplier!"

"Both mills running Pentagons. Last sets ran for about 11 months, pushing 13,000 to 14,000 ton per week. 572,000 tons of life on hammers!"

"The Triple Threat Hammers are working great on my Bliss Mill! Have to order another set! Got about 5.5 months out of them; I won't go anywhere else!"

"Dale said the Lightning Die he has on mill #2 has 600 hours on it and is still the best running mill!"