Hammer mill and Pellet Mill Replacement Parts

"Jacobs Hammers are amazing, can hardly see any wear on them!"

"The Triple Threats are living up to the talk on our Bliss Mill. [Competitor] hammers are needing replaced and Jacobs' barely looked used!"

"Very pleased with Bad Ax Hammers. Mill has less vibration, first corner 250 to 260 hours, 2nd corner at 180-190 and still going"

"Very happy with Jacobs Dies! Performing better than [Competitor]. Want another die like the last one."

"1st Die ran for 18 Months on 30 TPH mill and ran 172,278 Tons. 2nd Die installed July 7th 2015 and it is over 144,000 tons now and still going!"

"I am impressed with Jacobs Hammers, they last a long time!"

"We love your Hammers! They are more durable than the competitors, and that's why we're now using Jacobs Rod!"

"Josh said the Jacobs Die has out performed anything they have used in the past. Very pleased!"

"Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. "

"The Triple Threat Hammers have been working exceptionally well on our Jones Mill. I have been very impressed. We weren't getting the hours from [Competitor], and they were only lasting about 2 months. Jacobs has been running for 4 months and is still running for less money."