Hammer mill and Pellet Mill Replacement Parts
A Worldwide Leader in Replacement Parts for Mills Since 1934.
Our Mill Products & Services
Hammer Mills
Hammers
Rods and Spacers
Screens
Pellet Mills
Dies
Roller Shells
Die & Shell Rework
“Jacobs Hammers are amazing, can hardly see any wear on them!”
“Jacobs rods resist grooving much better than the other brands I have used in the past.”
“After we installed Pentagons, we saw a 50% increase in production with a finer grind.”
“Very happy with Jacobs Dies! Performing better than [Competitor]. Want another die like the last one.”
“The Jacobs Hammers are in the mill and outlasting the hammers we ran before!”
“Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. “
“Very pleased with Bad Ax Hammers. Mill has less vibration, first corner 250 to 260 hours, 2nd corner at 180-190 and still going”
“The Lightning Die has increased our production 30%+. The Die has been on for 4,000+ hours and still doing great. We added storage bins, which now was a waste of money as we have increased production and use the raw materials as fast as it comes in. I can’t believe the whole industry doesn’t jump to the Lightning!”
“Dale said the Lightning Die he has on mill #2 has 600 hours on it and is still the best running mill!”
“The Triple Threats are living up to the talk on our Bliss Mill. [Competitor] hammers are needing replaced and Jacobs’ barely looked used!”