Hammer mill and Pellet Mill Replacement Parts
A Worldwide Leader in Replacement Parts for Mills Since 1934.
Our Mill Products & Services
Hammer Mills
Hammers
Rods and Spacers
Screens
Pellet Mills
Dies
Roller Shells
Die & Shell Rework
“Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. “
“I am impressed with Jacobs Hammers, they last a long time!”
“Both mills running Pentagons. Last sets ran for about 11 months, pushing 13,000 to 14,000 ton per week. 572,000 tons of life on hammers!”
“We recently switched to Pentagon Hammers; the installer said the hammers went on so smooth, they thought something was wrong. Took 20 minutes to install 120 hammers. After a week, the hammers were inspected and there were a few sticking out. Touched them and they fell down. In the next two inspections, all hammers were down.”
“The Lightning resulted in 48% decrease in energy with 19% increase in throughput. Savings $32K!”
“There is no comparison out there to the durability of Jacobs Hammers, they’re amazing. Hardfacing is so good, the hammers are not wearing out. Only buying Jacobs Hammers!”
“It will be Jacobs from here on out! The guys said Jacobs Pentagons were by far the easiest to install and they really enjoy using them versus the others.”
“Essault Hammers lasted 11 weeks compared to regular hammers lasting 6 weeks. Ordered 2 more sets. This will be the way to go on hammers from now on!”
“Been using Pentagon X2 Holeformance for 3 weeks in Champion Mill. 60 AMPS savings so increased Feed Rate which increased throughput 8%. The Champion capacity is 65 Million and Currently Running at 70-71 Million. Easy to install and fewer spacers! We removed [Brand X] Hammers from a 2nd Mill and replaced with Pentagon X2 Holeformance to get the same savings and increased throughput.”
“Jacobs Hammers are amazing, can hardly see any wear on them!”