Hammer mill and Pellet Mill Replacement Parts

"The Triple Threat Hammers have been working exceptionally well on our Jones Mill. I have been very impressed. We weren't getting the hours from [Competitor], and they were only lasting about 2 months. Jacobs has been running for 4 months and is still running for less money."

"The hammers held up 4X longer than the previous hammers and price is great! Have now switched to Jacobs screens."

"After we installed Pentagons, we saw a 50% increase in production with a finer grind."

"Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. "

"I am impressed with Jacobs Hammers, they last a long time!"

"Dale said the Lightning Die he has on mill #2 has 600 hours on it and is still the best running mill!"

"Jacobs rods last a full year with very little grooving, competitors rods needed changed out every 6 months due to excessive grooving."

"The Jacobs Hammers are in the mill and outlasting the hammers we ran before!"

"Josh said the Jacobs Die has out performed anything they have used in the past. Very pleased!"

"The Lightning resulted in 48% decrease in energy with 19% increase in throughput. Savings $32K!"