Hammer mill and Pellet Mill Replacement Parts

"Josh said the Jacobs Die has out performed anything they have used in the past. Very pleased!"

"Very Happy with the Lightning Die and don't want to change a thing!"

"Lightning Die has better PDI by 15%, designed right for the DDG Formulation. Very impressed with quality up and AMP draw 15% less."

"Jacobs Hammers are amazing, can hardly see any wear on them!"

"Installing a replacement Pentagon set, the first one lasted 102 weeks!"

"We recently switched to Pentagon Hammers; the installer said the hammers went on so smooth, they thought something was wrong. Took 20 minutes to install 120 hammers. After a week, the hammers were inspected and there were a few sticking out. Touched them and they fell down. In the next two inspections, all hammers were down."

"Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. "

"Gold star for pentagons! We are getting the best grind we have ever had and are happy about that!"

"Extremely pleased with Jacobs Dies. Currently saving 50% more tons on these dies than we were getting with a different supplier!"

"Very pleased with Bad Ax Hammers. Mill has less vibration, first corner 250 to 260 hours, 2nd corner at 180-190 and still going"