Hammer mill and Pellet Mill Replacement Parts

"Very happy with Jacobs Dies! Performing better than [Competitor]. Want another die like the last one."

"Extremely pleased with Jacobs Dies. Currently saving 50% more tons on these dies than we were getting with a different supplier!"

"Our pelleting process had some inefficiencies, we were seeing rather poor performance from our process and short lifespans from our dies and rolls. . With Jacobs we built a new protocol for our process, from our feed temps, all the way through roll setups. We have been running for several months now and our pelleting production numbers are fantastic, some of our products we increased our performance by over 50%, that translates to multiple tons per week in increased efficiency. We did see an increase in all of our TPH across the board. "

"The Triple Threat Hammers are working great on my Bliss Mill! Have to order another set! Got about 5.5 months out of them; I won't go anywhere else!"

"Jacobs rods last a full year with very little grooving, competitors rods needed changed out every 6 months due to excessive grooving."

"Been using Pentagon X2 Holeformance for 3 weeks in Champion Mill. 60 AMPS savings so increased Feed Rate which increased throughput 8%. The Champion capacity is 65 Million and Currently Running at 70-71 Million. Easy to install and fewer spacers! We removed [Brand X] Hammers from a 2nd Mill and replaced with Pentagon X2 Holeformance to get the same savings and increased throughput."

"Very pleased with Bad Ax Hammers. Mill has less vibration, first corner 250 to 260 hours, 2nd corner at 180-190 and still going"

"Ron said the Die works perfect! He wanted 3 tons per hour and got 5 Tons and is still achieving a better pellet. Is happy with the die and it will be Jacobs Exclusively from here on out!"

"I am impressed with Jacobs Hammers, they last a long time!"

"The Jacobs Hammers are in the mill and outlasting the hammers we ran before!"